本文提出了一種基于ARM和Ethernet現場實時動態信號采集分析系統的軟硬件系統實現方案。該方案通過采用ARM+DSP主從結構、嵌入式LINUX系統及合理任務分配策略保證了系統的實時性要求，并將網絡數據傳輸率需求控制在可行范圍內。討論了Ethernet 應用于工業測試診斷系統的相關關鍵技術問題。
關鍵詞: 信號分析; Ethernet; DSP; ARM; 嵌入式LINUX系統
Abstract: This paper presents a realization of real-time dynamic data collection and signal
analysis system based on Ethernet and ARM both in software and hardware. By using ARM+DSP master slave system, embedded LINUX and reasonable task-assigned strategy, the system demand for real-time and data transmission speed of network are guaranteed. Finally, several key technical problems about Ethernet used in industrial tests and diagnosis are discussed.
Key words: signal analysis；Ethernet；DSP；ARM；embedded LINUX